DiMarzio Forum
DimarzioForum.Com => The Pickup Place => Topic started by: Bucksears on October 09, 2019, 07:21:54 PM
-
About a year or so ago, I swapped out the A5s in one of my PAF 36th sets for A4s. They were weak, which isn't surprising, but I wanted to give those a run.
Now I've got the pickups apart again, and wanted to de-air them, but leave the A4 magnets in.
The neck pickup went fine, the spacer bar fit, all is well. I ordered some 53mm spacer bars, and they don't fit a DiMarzio F-spaced pickup due to its 51.5mm spread (which I found out later).
So, where can I find spacer/keeper bars to fit? Find broken DiMarzios and scavenge the parts?
-
They sell 50mm keepers here. I’ve never seen a 51 or 52mm keeper.
https://www.mojotone.com/guitar-parts/Keeper-Bars
Sent from my iPhone using Tapatalk
-
Wound up using a 3/32" x 2" cotter pin that straightened out and cut to fit magnet width. I put the magnet against the screws and used the straight cotter pin piece as a shim on the slug side; fit perfectly. It's magnetic, so we'll see how it goes.
-
That should work. DiMarzio uses metal shims on a few pickups. You can use key way stock for shims
Sent from my iPhone using Tapatalk