Installing new 4 conductor pickups into existing two wire harness?

  • 2 Replies
  • 4245 Views

0 Members and 3 Guests are viewing this topic.

*

theoctavist

  • Guest
the existing harness just has two wires, white and black. to avoid futzing with soldering to the pots, i want to just solder the new 4 wires into the old harness. the new pickups are 4 conductor. (they are a diy/knockoff brand). any ideas? the old pickups just have two wires, white and black. thank you.

*

Offline corypheus

  • Full Member
  • ***
  • 164
  • 12
    • View Profile
Re: Installing new 4 conductor pickups into existing two wire harness?
« Reply #1 on: April 05, 2017, 06:08:21 AM »
No problem there, just jump-in the othe two wires (as in connect together) and not on the pots, and install the pickup as if it one/two conductor. Take a look at DiMarzio charts to see which color represents which so you have no headache connecting it. That's that.

HTH,
Cory

*

Offline daenius

  • Newbie
  • *
  • 28
  • 1
    • View Profile
Re: Installing new 4 conductor pickups into existing two wire harness?
« Reply #2 on: April 05, 2017, 03:08:39 PM »
4 conductor humbuckers can be wired pretty much the same as single conductor

All you have to do is solder the South of the 2 coils together. In the case of Dimarzio, you solder Black and White together, and just tape it up. You then solder Red to Hot, and Green+Bare to Ground.

If you have Duncans, the color codes are different. Every brand is different so CHECK THE COLOR CODE FIRST!!