46
The Pickup Place / Re: Too boomy Evolution neck
« on: March 17, 2017, 03:24:51 PM »
Agree. It depends on pickup itself.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
What I did to some neck humbuckers to de-muddy them was to remove either the screws under the 6th and 5th strings on the neck side coil or to remove the screws under the bass strings from the neck side coil. This has worked well for several pickups. However, if the pickup is covered I found the effect to be minimal and not enough.It seems like I have found solution. Trick with screws really helped me. But I just did it with a little different way. Just lowered down pickup itself from strings and rised up all screws for a 2mm. It is not perfect what I want but far better than it was before.
This is a trick that was posted here by RayBarbeeMusic before.
Good luck,
Stephan
Did tried Fast Track 2 in parallel mod?Definetely incector neck. 160-mV + really close to the strings (has low magnet pull) will give you nice ballance with evo 2. Have to say that injector works great with 500k pot. Remamber that you can split injector (it's south up) in paralell with north coil of evo 2 - great strat in between sound.
Errrr......if he thinks the Chopper (260mV) has too low output for him then the Injector (160mV) is hardly a good choice.
That said, I think all of the Dimarzio railbuckers are pretty dark. I'd love to have a hotter Satck Track with more top end. That would be the perfect SC size neck humbucker for shredding
Definetely incector neck. 160-mV + really close to the strings (has low magnet pull) will give you nice ballance with evo 2. Have to say that injector works great with 500k pot. Remamber that you can split injector (it's south up) in paralell with north coil of evo 2 - great strat in between sound.My Virtual Solo has 200mV and it is still too quite for me. Need something more powefull. And my guitar with floyd rose. Can't make pickup too close to the strings.