Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - iGeetjis

Pages: [1]
1
The Pickup Place / Chopper T in tele bridge - 250k or 500k tone pot ?
« on: August 24, 2022, 11:34:53 PM »
fender tele with these pups:
Harmonic Design S-90 in neck position
Dimarzio Chopper T bridge position

dimarzio diagram calls for 500k tone pot but in my tele the pots are 250k V & T.

will this make much of an issue or should i need to put in a 500k tone pot?

also to verify, to keep the Chopper in phase with the single coil neck pickup i should make the Green wire hot and the Red wire ground versus other way around?

tia

2
The Pickup Place / Tele neck PU to compliment Chopper bridge
« on: May 14, 2021, 03:45:36 PM »
i have a 2015 American Standard Tele. single neck PU, Reilander, and SD Pearly Gate single humbucker.  i tried to like the Pearly Gate but it's not happening. so i want to replace it with the DiMarzio Chopper T in bridge. i figure i might as well replace the neck too.

i don't want a very twangy neck pu though. i like the Tele neck to lean more to an agressive warm type tone. this guitar usually plays bluesy stuff, power chord types. but i do try my hand at 3 note/shell voicings attempting to sound a little jazzy.

with that written, can i get a few neck PU recommendations to compliment the Chopper T pls. 
tia


Pages: [1]