Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - riffwraith

Pages: [1]
1
The Pickup Place / Re: Super Dist Q
« on: August 03, 2019, 03:12:39 PM »
HTF - your initial idea was spot on. Got the colors correct, and all is well.

Thanks!

2
The Pickup Place / Re: Super Dist Q
« on: August 03, 2019, 03:12:03 PM »
The wiring diagrams available on the DiMarzio site should lay it out for most any config. Have you already checked there?

Yeah - too many choices... too complicated  :o

3
The Pickup Place / Re: Super Dist Q
« on: July 27, 2019, 11:24:34 PM »
Aha! That could explain why I all of a sudden have some hum.

So, found this:

(below)

Where TA is first...

Does this mean that I need to go BL > GR, WH > WH, GR > RED, RED > BL?

Will be easy enough if yes.

What's M.P., btw?

Thank you!

4
The Pickup Place / Super Dist Q
« on: July 27, 2019, 05:58:07 PM »
Hi everyone :)

I am replacing the bridge humbucker in my '96 Tom Anderson Drop-Top. I have a Super Dist, that I have wired as the TA p/u was wired - real easy, r > r, bl > bl, etc.

The guitar is plugged into my hi-gain Marshall. When I lightly run a screwdriver over the poles of the TA p/u, I hear a that good 'ol scratchy noise... the noise sounds the same on poles in both bobbins.

Not so with the SDist; one bobbin sounds like the TA, and the other has some, but not nearly as much.

Does anyone know if this is normal? Would someone mind checking? :) My soldering is not exactly world-class, so it's possible there is something awry there.

Thanks in advance.

Pages: [1]