Where to find 51.5mm spacer?

  • 3 Replies
  • 4350 Views

0 Members and 1 Guest are viewing this topic.

*

Offline Bucksears

  • Newbie
  • *
  • 28
  • 0
    • View Profile
Where to find 51.5mm spacer?
« on: October 09, 2019, 07:21:54 PM »
About a year or so ago, I swapped out the A5s in one of my PAF 36th sets for A4s. They were weak, which isn't surprising, but I wanted to give those a run.
Now I've got the pickups apart again, and wanted to de-air them, but leave the A4 magnets in.

The neck pickup went fine, the spacer bar fit, all is well. I ordered some 53mm spacer bars, and they don't fit a DiMarzio F-spaced pickup due to its 51.5mm spread (which I found out later).

So, where can I find spacer/keeper bars to fit? Find broken DiMarzios and scavenge the parts?
« Last Edit: October 10, 2019, 12:38:40 PM by Bucksears »

*

Offline DavidSchwab

  • Jr. Member
  • **
  • 82
  • 6
    • View Profile
Re: Where to fine 51.5mm spacer?
« Reply #1 on: October 09, 2019, 07:28:53 PM »
They sell 50mm keepers here. I’ve never seen a 51 or 52mm keeper.


https://www.mojotone.com/guitar-parts/Keeper-Bars


Sent from my iPhone using Tapatalk

*

Offline Bucksears

  • Newbie
  • *
  • 28
  • 0
    • View Profile
Re: Where to find 51.5mm spacer?
« Reply #2 on: October 14, 2019, 03:15:22 PM »
Wound up using a 3/32" x 2" cotter pin that straightened out and cut to fit magnet width. I put the magnet against the screws and used the straight cotter pin piece as a shim on the slug side; fit perfectly. It's magnetic, so we'll see how it goes.

*

Offline DavidSchwab

  • Jr. Member
  • **
  • 82
  • 6
    • View Profile
Re: Where to find 51.5mm spacer?
« Reply #3 on: October 14, 2019, 03:19:16 PM »
That should work. DiMarzio uses metal shims on a few pickups. You can use key way stock for shims


Sent from my iPhone using Tapatalk